Some Linux DVB drivers, in particular for the Hauppauge Nova-T, require that we slow down the tuning process by specifying a delay (in milliseconds). If you have more than one tuner of the same type using the same Video Source, only one tuner needs to have this Checked. When this option is enabled the DVB card is constantly in-use. If enabled, activate active scanning for program data (EIT). If enabled, only open the DVB card when required, leaving it free for other programs at other times. If enabled, drop packets from the start of a DVB recording until a sequence start header is seen. This is only useful if you have two recordings at the same time from two channels that share the same frequency. Some digital transmitters transmit multiple programs on a multiplex, if this is set to a value greater than one MythTV can sometimes take advantage of this. Maximum number of simultaneous recordings this device should make. Alternatively set to 10000, this does not affect normal operation as the timeout is cancelled as soon as tuning is successful. If Live TV or recordings fail you may need to increase this. For recordings, this value will be doubled. Maximum time (in milliseconds) MythTV waits for a channel lock. Alternatively set to 7000, which whilst increasing time for a channel scan, makes missing channels very unlikely. If it is missing channels on the channel scan, increase this value. Maximum time (in milliseconds) MythTV waits for a signal when scanning for channels. If there is nothing in the list you will need to investigate whether Linux supports the card and how to get it working. If Linux recognizes your device it will appear in the list. If the card cannot be opened, an error message will be displayed. When you change this setting, the text below should change to the name and type of your card. Configure the digital portion as a DVB card, then click on the "Analog Options" button within the DVB configuration panel for the card and configure the analog portion of the card there. If you have a dual digital/analog card, such as the pcHDTV cards and some DViCO cards, then you should not configure this as two separate cards. There are articles about each type of tuner in the relevant categories. To see if your card is supported, see the list of cards in the "Supported Hardware" section of the DVB Wiki at for more information. Support for these devices depends on drivers supplied by. Different standards apply to different countries. These capture cards are digital TV tuners, able to receive digital TV signals from various sources, such as over the air, cable TV or satellite. 8 Card type: Analog to MPEG-2 encoder card (PVR-150/250/350, etc)Ĭard type: DVB-T/S/C, ATSC or ISDB-T tuner card.4 Card type: TV Gateway networked tuner.1 Card type: DVB-T/S/C, ATSC or ISDB-T tuner card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |